1:10scale 4wd Nitro Power rc Buggy-winner

TECHNICAL PARAMETERS
Length.............................400mm
Width..............................245mm
Height.............................170mm
Wheelbase......................270mm
Tread..............................245mm
Wheel Diameter..............88*34, 88*41mm
Gear Rate........................8.3:1
Weight............................1900g
Engine.............................15CX

FEATURES
ALUMINUM CHASSIS (2mm)
DISC BRAKE SYSTEM
ORIGINAL MUFFLER AND AIR FILTER
FOUR WHEEL DRIVE SYSTEM
OIL-FILLED SHOCK ABSORBER
BUILT-IN DIFFERENTIAL BEVEL GEAR
15CX ENGINE EQUIPPED WITH SLIDE CARBURETOR AND PULL STARTER
ADJUSTABLE "X" SUSPenSION SYSTEM

2-Channel Transmission System
Before you assemble this car, you must set the servo to
the center position. To do that, switch on the transmitter
and receiver first, then pull the trimmer rod to the middle,
after that, switch offthe receiver and transmitter,
the servo will be at correct position.