Solar Portable Hand Lamp

Detailed Product Description
 Solar Panel: 2.5W
            Battery: 6V/4AH
            Light Source: 7W fluorescent U-tube
            Color: black
            Material: PC/ABS
            Charging time: 7-8hrs by AC Power; 12-15hrs by Solar Panel
            Working time: around 6 successive hours after fully charged.
            Function: with AC charging Adapter, car battery charging adapter and
            remote controller, Suitable for isolated homes, shops, restaurants,
            hospitals and schools. They are especially suitable for remote
            mountain regions, fishing boats, tourist sites, outdoors fields and
            other places where electricity is short in supply. They are
            waterproof, durable and environmentally friendly products with novel
            design and compact dimension. They will undoubtedly be widely
            accepted by the new generation.
            Usage instruction:
            1. Always pay attention to the indicator board and please be sure to
            charge battery before using when the "LOW" indicator becomes Red and
            stop charging when the "FULL" indicator becomes Red.
            2. Please keep the solar modules/panel face the sun. Plug the solar
            panels jack into the main board solar panel charging socket. Always
            keep a right angle if possible in order to have a better sunlight
            collecting effect. You can fix and adjust the solar panels angle
            according to the latitude in your areas.
            3. When use the system, please keep the switch on the main board
            "ON" and "OFF" when you stop using or in repair. put the "FUSE" off
            if long time dont use the system.
            4. Keep the control box in a dry place and any outside severe shocks
            should be prevented.
            Cautions:
            1. Keep the surface of the solar panel clean and avoid knocking at
            it.
            2. To charge, set the switch to OFF and connect for charging by
            inserting the charging plug in the jack socket
            3. Move the switch as little as possible after the unit has been
            charged and turned on. This will ensure that the protective circuit
            works correctly. If the lamp has been used for a long time then the
            protective circuit may prevent the lamp from operating, then
            switched on again. This is a normal phenomenon and indicates the
            battery needs to be recharged. Keep the switch off when the remote
            control has not been used for some time in order to save energy.