1:10th Scale Nitro On Road Touring Car-Two Speed

This 1/10 Scale 4WD nitro gas powered on-road touring car is of two speed transmission. Other than the same scale hobbies, on-road touring cars would never fail to run faster on flat surfaces than other hobbies cars do. All on-road touring cars are built in low chassis design and provides aligned running in line.

Specifications:
Vehicle length: 360mm
Vehicle width: 200mm
Height: 112mm
Wheelbase:260mm
Track:195mm
Gear Radio: 1:5.428(H)
                        8.039:1(L)
Ground clearance:4.5mm
Wheel :Approx.1665g
Wheel Diameter:65mm
Wheel width:26mm
Engine level:16/18 cxp
Specific ations are subject to change without notice in advance

1.Four wheel straight shaft drive system
2.Front/rear differentials with good quality bevel gears as well as with 5 screws
easy for maintenance.
3.6061/T6 solid anodized alum. chassis
4.13.8g lightweight alum. flywheel allows for quick engine response
5.Solid universal joint Cup/high performance ball bearings complete
6.Disc brake system with user replaceable pads provides quick brake response
7.Extra large Capacity leak proof fuel tank with the overflow pipe and spring load fill
cover for quick re-filling
8.Pre-trimmed V-tread durable tires
9.Oil filLED shock springs and good quality shock absorbers provide excellent shock
protection.
10.High flow dual foam element air filter(user serviceable)
11.Large front bumper with good quality sponge provide good protection against accident impacts